1 / 2
Irregular Gridfinity Storage Bin for Husky Workbenches
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Irregular sized gridfinity bins to fill the space of a Husky workbench
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 472
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 1)Remiksy (0)Kolekcje (23)Powiązane
I wanted to maximize the storage space the Husky workbench drawers. Using the baseplates by 64bitcube there was still a little bit of room at the rear of the drawers. These bins will make use of that space, a little over ½ of a standard gridfinity bin.
Features
- These are 1 x 1sh x 6 bins. They may require modifying the drawers of your workbench to fit the height. It seems a lot of these workbenches have the front of the drawer deeper than the rear.
- They have no base on the partial section. This will require supports but will allow you to easily insert and remove the bin by only removing the bin in front if it first.
- The label area has been extended so you use a 12mm/0.47" tape and still read it while in the drawer.
If there are other sizes of bins you'd like please leave a comment and I'll try to add them.