Raspberry Pi 5 + Pimoroni NVME Base Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remix of pyrho's Pi 5 case with support for the Pimoroni NVME Base added + Now with support for NVMe Base Duo
- Ocena
- 4,893 / 5
- Polubienia
- 212
- Pobrania
- 2447
- Wydruki
- 32
- Wyświetlenia
- 12 545
- Oceny
- 28
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
I recently received the NVME Base by Pimoroni for my Raspberry Pi 5. I noticed that there are only a few cases which accommodate it. I was sure that I could remix a nice case to change that. Here it is…
Update: Added different bottom shell for NVMe Base Duo (long term usage not tested)
A Pimoroni NVMe Base Duo was kindly provided by RaspberryStore.nl , as a reference.
#HowTo Print
Place the halves of the case with their largest flat side facing towards the print-bed. The material is your choice. I simply used PLA. I used 0.15mm Layers but everything ≤0.2mm should work.
#HowTo Assemble
- Install the NVME Base to your Pi by following Pimoroni's installation-instructions (https://youtu.be/odG7FbptgWQ).
- Insert the assembly carefully into the bottom shell with the NVME-base facing down and the micro-SD-slot facing its designated opening.
- Snap fit the top and you are done! 🎉