Upgrade for the K1 ONLY, The Alien nozzle wiper. Try at your own risk on other K1 variants.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This will allow you to add a silicone nozzle brush to your K1 (maybe even the K1 Max?).
- Ocena
- 4 / 5
- Polubienia
- 72
- Pobrania
- 237
- Wydruki
- 1
- Wyświetlenia
- 5889
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
UPDATE: 2024-11/22 This was only designed for the K1. Try this mod on K1 Max, K1C, and K2 at your own risk and expense.
UPDATE: 2024-02/18 still randomly interferes with bed mesh calibrations; for now, make this change to your printer.cfg.
Find this section [bed_mesh]
Change this line from mesh_max: 215,215 to mesh_max: 215,205
This keeps the probing away from the wiper.
UPDATE: 2024-02/14, moved the wipers back about 1mm and beveled the edge to avoid interfering with Self-check bed leveling or bed mesh probing.
I saw that the K1C would have a silicone brush mounted to the build plate; I don't think most would like to have to get a Creality-only build plate for the silicone wiper. So, I designed "The Alien" that mounts to the rear lead screw nut. I have added a little wiggle room in the mount holes to provide the ability to square up with the build plate.
Remove as much of the wiped filament from the area before mounting; too high off the build plate may cause problems.
Print in a filament that is not flexible at your highest print bed temp.
I print in ABS & ASA; ABS bed temp 110C, so I printed mine with ASA since it can withstand 110C.
- We need the silicone brush by Bamboo Labs, a part for the A1 mini.
- You must peel out the silicone brush piece from the A1 mini holder.
- Then, cut the brush in half (not long enough for the K1 wipe); there are 14 nubs, cut after the 7th.
- After printing "The Alien", you must glue (no 3M tape, too thick) the silicone brush halves into the print.
- Remove the two front screws from the rear lead screw nut, put one screw fully into "The Alien" and just start the other one.
- Install on to the lead screw nut.