1 / 4
Upgrade for the K1 ONLY, The Alien nozzle wiper. Try at your own risk on other K1 variants. — image 1
1 / 4

Upgrade for the K1 ONLY, The Alien nozzle wiper. Try at your own risk on other K1 variants.

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This will allow you to add a silicone nozzle brush to your K1 (maybe even the K1 Max?).

Rating
4 / 5
Likes
72
Downloads
237
Makes
1
Views
5,889
Reviews
1

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

UPDATE: 2024-11/22 This was only designed for the K1. Try this mod on K1 Max, K1C, and K2 at your own risk and expense.

UPDATE: 2024-02/18 still randomly interferes with bed mesh calibrations; for now, make this change to your printer.cfg.

Find this section [bed_mesh]

Change this line from mesh_max: 215,215 to mesh_max: 215,205

This keeps the probing away from the wiper.

 

UPDATE: 2024-02/14, moved the wipers back about 1mm and beveled the edge to avoid interfering with Self-check bed leveling or bed mesh probing.

I saw that the K1C would have a silicone brush mounted to the build plate; I don't think most would like to have to get a Creality-only build plate for the silicone wiper. So, I designed "The Alien" that mounts to the rear lead screw nut. I have added a little wiggle room in the mount holes to provide the ability to square up with the build plate. 

Remove as much of the wiped filament from the area before mounting; too high off the build plate may cause problems.

Print in a filament that is not flexible at your highest print bed temp.

I print in ABS & ASA; ABS bed temp 110C, so I printed mine with ASA since it can withstand 110C.

  1. We need the silicone brush by Bamboo Labs, a part for the A1 mini.
  2. You must peel out the silicone brush piece from the A1 mini holder.
  3. Then, cut the brush in half (not long enough for the K1 wipe); there are 14 nubs, cut after the 7th. 
  4. After printing "The Alien", you must glue (no 3M tape, too thick) the silicone brush halves into the print.
  5. Remove the two front screws from the rear lead screw nut, put one screw fully into "The Alien" and just start the other one.
  6. Install on to the lead screw nut.

Tags