IKEA Kungsfors Mount for Top Shelf
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I wanted to secure a wooden plate to the top of the Kungsfors rack, this is what I came up with.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 481
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Idea
After installing a few IKEA Kungsfors racks on my kitchen wall, I noticed that the hooks on the bottom were sometimes a bit hard to manage when something was placed on top of the rack. Also, the top surface isn't smooth, especially when you pair a few racks side by side. I wanted to mitigate that by placing a wooden sheet on top of the racks and fasten it down with a few 3D-printed brackets.
Printing
The print is quite simple, no supports and enough brackets to secure your shelf; I went with four per rack, one in each corner. Probably less would do, especially when the racks are placed side by side, but I like the cohesive look. Printed in PETG, standard settings and 3 perimeters.
Other parts
When measuring I noticed each rack was 80 cm wide and 30 cm deep with a bit room behind it, so I opted for an overhang of 1 cm to each side. I went with a 15 mm thick wooden plate, which was filleted on all edges, sanded and treated with food-grade oil for wooden work surfaces.
I designed it for two 3,0x35 mm countersunk screws each, which then protrude 10 mm out into the wooden piece.