Mister FPGA Terasic DE10 Nano Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a case for a minimalistic MiSTer setup with no I/O board and no USB hub board. It is designed for vertical RAM…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 607
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
This is a case for a minimalistic MiSTer setup with no I/O board and no USB hub board. It is designed for vertical RAM modules and the popular Noctua NF-A4x10 5V fan (any 40x40 5V fan will do the job). When installing the board, make sure to slide the side with the power and HDMI connectors in first, then very gently and carefully press the side with the Ethernet connector down until it snaps in place. There are openings for three push-buttons. See this thread for information on how to connect the buttons: https://misterfpga.org/viewtopic.php?t=1492
Make sure that you don't miss to get an DE10 Nano heatsink up to 10mm in height.
Enjoy!
Print Settings
Rafts:
No
Supports:
No
0,2
Infill:
20
Filament:
Prusament, Das Filament, e.g... PLA, PETG
Notes:
Mine was printed on Pusa Mini+. Total print time around 4h body and 1,5h cover.
Category: Electronics