1 / 5
LED separators
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small holders to keep LED legs separated to stop short circuits. Fits crocodile clips.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 172
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
Various designs of LED holder, to keep LED legs and crocodile clips separated when making circuits.
The tube design makes a good insulated connection, the open base design is less fiddly, so easier for children to use.
To print:
- Flip all of the files upside down for best results.
- They are tiny, so check your bed adhesion / add a brim if needed.
- I printed in PLA, 0.2mm layer height, 15% infill - it probably doesn't matter too much what settings you use.
Files included:
- With tubes
- 1x LED
- 2x LED with shared ground in a row
- 2x LED with (optional) shared ground in a column
- Open base
- 1x LED
- 2x LED with shared ground in a row
- 2x LED with (optional) shared ground in a column
Improvements to be worked on at some point…
- Flip the parts, so I don't need to manually do it in the slicer.
- The +/- signs don't show up very well. I would like it to be visible at 0.2mm layer height to save on printing time as I print lots at once for educational use.
- The shared ground on the tubed column design isn't as secure as the others - the LED wires could be guided at an angle.