1 / 3
Kinesis Advantage Orifice Plug
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For the O.G. Advantage, this plugs holes if you have replaced the logic board.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 214
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
I replaced the logic board in my Kinesis Advantage with the KinT controller. This deletes the original cables, and leaves you with holes in the back where your USB cable gets run. Instead of trying to reuse the original grommets, I made these.
The strain relief plug needs to be cut down its axis to wrap around a cable. I used a very sharp razor blade for this and was very successful.
The blank plug is not D shaped like the hole, but fits without issue on my keyboard.
All parts:
- Print in TPU
- Supports aren't really possible, some post processing with a razor may be necessary
- I highly recommend “concentric” top and bottom layers
- OpenSCAD model available if different sizing is preferred
- The BOSL2 library is required to use this SCAD document