Prusa Enclosure Ventilaton(80mm Fan-80mm Hose or 80mm Fan-100mm Hose)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
80mm Ventilaton System Prusa Enclosure (80mm Fan-80mm Hose or 80mm Fan-100mm Hose)
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 456
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Update 14.03.2024:
Filter attachment with slot for 80x80x10mm filter added.
Parts for ventilating the Prusa Enclosure using an 80mm fan:
consisting of:
inner part
outside part
80mm hose adapter (OD76mm)
optional:
100mm hose adapter (OD98mm)
Cover cap for 80mm fan
Filter attachment for 80mm fan (an 80x80mm filter should fit in)
Filter attachement for 80x80x10mm Filters
Cover cap for filter attachment
Switch box (switch recess 19.2x13mm)
Mounting: (M3 screws and nuts)
After the inner and outer parts have been assembled, it is necessary to re-drill the inner holes for the 80mm fan and the hose adapter on the enclosure (3 or 3.5mm drill), as these holes overlap slightly with the rear panel.
I mounted the 80mm fan inside, but it can also be mounted outside between the hose adapter and the outside part (but without a filter attachment or cover cap)
I had the 80mm fan + a power supply lying around - that's why this mod...
Depending on printer calibration, it may be necessary to slightly scale or rework parts. All parts printable without supports.
---------------------------------------------------------------------------------------------------
Update 14.03.2024:
Filteraufsatz mit Einschub für 80x80x10mm Filter hinzugefügt.
Teile zur Entlüftung des Prusa Enclosures mittels eines 80mm Ventilators.
bestehend aus:
Innenteil
Aussenteil
80mm Schlauchadapter (AD76mm)
optional:
100mm Schlauchadapter (AD98mm)
Abdeckkappe für 80mm Fan
Filteraufsatz 80x80mm
Filteraufsatz für Filter 80x80x10mm
Abdeckkappe für Filteraufsatz
Schalterbox (Schalterausnehmung 19,2x13mm)
Montage: (M3Schrauben und Muttern)
nachdem Innen- und Aussenteil montiert wurden, ist es notwendig die inneren Bohrungen für den 80mm Fan und den Schlauchadapter am Enclosure nachzubohren (3 oder 3,5mm Bohrer), da sich diese Bohrungen mit dem hinteren Panel geringfügig überschneiden.
Ich habe den 80mm Fan im Innenraum montiert, er kann allerdings auch Aussen zwischen Schlauchadapter und Aussenteil montiert werden (allerdings ohne Filteraufsatz oder Abdeckkappe)
Ich hatte den 80mm Fan + ein Steckernetzteil dafür rumliegen - darum dieser Mod…
Je nach Druckerkalibrierung kann es notwendig sein, die Teile geringfügig zu skalieren oder nachzuarbeiten. Alle Teile ohne Stützen druckbar.