NA Miata Vent Ring RAM Ball Phone Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ball mount based phone holder for a NA/NB Miata
- Ocena
- 0 / 5
- Polubienia
- 24
- Pobrania
- 375
- Wydruki
- 0
- Wyświetlenia
- 2551
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
Ball mount based phone holder for a NA/NB Miata that replaces the factory vent ring.
The clips that hold the vent ring in place are a little loose in the source model, I opted to not modify them and instead add a spacer via small piece of felt to also help reduce rattling. I'm not a mechanical engineer, so the geometry is made for simplicity not strength optimization.
Requires the use of a 17mm ball mount magnetic phone holder, I purchased mine on Aliexpress.
The volume of the print is quite small so I printed with PETG at 50-100% infill for use with a iPhone 11 Pro. Ideally you would use ASA or similar as this has not been tested in the Texas heat yet.