1 / 6
Hot Water Heater Mount for WeMos/LOLIN D1 mini Enclosure — zdjęcie 1
1 / 6

Hot Water Heater Mount for WeMos/LOLIN D1 mini Enclosure

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This mount will allow to use WeMos/LOLIN D1 mini Enclosure instead standard thermometer

Ocena
0 / 5
Polubienia
1
Pobrania
17
Wydruki
0
Wyświetlenia
289
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

The original WeMos D1 mini Enclosure made by 100prznt is such nice component, that I wanted to use it for replacing standard thermometer in my 300L Water Heater tank. So I made accessories for it - the Water Heater Mount. This mount is fully compatible with original parts (after drilling hole for sensor).

The Vater Heater Mount:

Designed for original Dallas Temperature Sensor DS18B20 and space for hiding 1m cable length. Max. cable dia. 4mm.

Mount will slide into plastic flange - flange dia. is 34,8mm (without groves 34mm)

Supporting original cover and two styles of screws:

  • the D3 version is for self drilling screws and holes are 3mm dia.
  • the M4 version is for M4 Threaded insert e.g. CNC Kitchen (long/short), holes 5,6mm dia.

My printing setup:

Material: Prusament PETG
Nozzle diameter: 0.4 mm
Layer height: 0.2 mm
Infill density: 100%
Support: Yes
Filament used: 32g
Print time: cca 2:45h

The D1 mount remix:

Designed for Wemos/LOLIN D1 mini V4 version (USB-C). I'm recommending to screw the PCB - so there is preparation for drill the holes based on your preference. Sensor cable has output on the back. You can insert Wemos after sensor soldering, there is 7mm hole - enough for Dallas probe. Try to use some slim USB-C cables.

My printing setup:

Material: Prusament PETG
Nozzle diameter: 0.4 mm
Layer height: 0.2 mm
Infill density: 25% Gyroid
Support: No
Filament used: 14g
Print time: cca 1:15h

The Cover remix:

The sensor groove was removed from original model

My printing setup:

Material: Prusament PETG
Nozzle diameter: 0.4 mm
Layer height: 0.2 mm
Infill density: 15% Gyroid
Support: No
Filament used: 18g
Print time: cca 1:30h

Tagi