Hot Water Heater Mount for WeMos/LOLIN D1 mini Enclosure
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This mount will allow to use WeMos/LOLIN D1 mini Enclosure instead standard thermometer
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 17
- Makes
- 0
- Views
- 290
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The original WeMos D1 mini Enclosure made by 100prznt is such nice component, that I wanted to use it for replacing standard thermometer in my 300L Water Heater tank. So I made accessories for it - the Water Heater Mount. This mount is fully compatible with original parts (after drilling hole for sensor).
The Vater Heater Mount:
Designed for original Dallas Temperature Sensor DS18B20 and space for hiding 1m cable length. Max. cable dia. 4mm.
Mount will slide into plastic flange - flange dia. is 34,8mm (without groves 34mm)
Supporting original cover and two styles of screws:
- the D3 version is for self drilling screws and holes are 3mm dia.
- the M4 version is for M4 Threaded insert e.g. CNC Kitchen (long/short), holes 5,6mm dia.
My printing setup:
Material: Prusament PETG
Nozzle diameter: 0.4 mm
Layer height: 0.2 mm
Infill density: 100%
Support: Yes
Filament used: 32g
Print time: cca 2:45h
The D1 mount remix:
Designed for Wemos/LOLIN D1 mini V4 version (USB-C). I'm recommending to screw the PCB - so there is preparation for drill the holes based on your preference. Sensor cable has output on the back. You can insert Wemos after sensor soldering, there is 7mm hole - enough for Dallas probe. Try to use some slim USB-C cables.
My printing setup:
Material: Prusament PETG
Nozzle diameter: 0.4 mm
Layer height: 0.2 mm
Infill density: 25% Gyroid
Support: No
Filament used: 14g
Print time: cca 1:15h
The Cover remix:
The sensor groove was removed from original model
My printing setup:
Material: Prusament PETG
Nozzle diameter: 0.4 mm
Layer height: 0.2 mm
Infill density: 15% Gyroid
Support: No
Filament used: 18g
Print time: cca 1:30h