DJI O3 Antenna Mount for Rotoroma Buddy FPV Frame - Fully Customizable - OpenSCAD
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fully customizable Antenna Mount for the DJI O3 AirUnit Antenna for the Rotoroma Buddy FPV Frame.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 69
- Wydruki
- 0
- Wyświetlenia
- 244
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
The original Rotoroma O3 Antenna Mount is fine, but I wanted to designed my own for perfect fit.
I am flying the Rotoroma Buddy 5" Deadcat, but my model should work with any Rotoroma Buddy frame. With slight modification of the variables, my model should be easily adaptable for other frames as well.
Customizability
The model is designed in OpenSCAD with maintainability and customizability in mind. Every part is a separate module and there exists a variable for every dimension. If you need help modifying my model, leave me a message or write a comment.
Depending on your specific setup, you may want to slightly modify these variables:
standoff_height: If you want to mount multiple things at the back standoffs, you may want to reduce the standoff height here.
antenna_length: If your O3 Air Unit is mounted very very far to the front or back, you may want to modify the antenna length. The default value should be fine for most setups, however.
antenna_slot_width: If you aren't printing this part with TPU and are having trouble clicking the antenna into the mount, you may want to increase the slot width.
antenna_angle: Modify this to your liking.
antenna_z_offset: This moves the antenna rod on the z-axis.
Printing
I suggest printing the mount on its side with the antenna rot going up. That way you should not need any supports.