1 / 11
Qidi X-Max 3 HEPA + carbon chamber filter (80x80 fan mount) — zdjęcie 1
1 / 11

Qidi X-Max 3 HEPA + carbon chamber filter (80x80 fan mount)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mainly for those who predominantly print PLA, where the HEPA is more important than the activated carbon.

Ocena
0 / 5
Polubienia
20
Pobrania
96
Wydruki
0
Wyświetlenia
1003
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

HEPA (+ activated carbon) adapter for the Qidi X-Max 3, uses a Levoit LV-H128 replacement filter.

(Yes, the carbon is not pellet based, just an activated carbon impregnated sponge but I mainly print with PLA. And have a 550 CADR standalone purifier)

Disclaimer / tips:

- The additional sliding cover is just for OCD, to eliminate any unfiltered leakage around the filter, which has a foam padded edge. The ensclosure is tapered, the foam is compressed when insterted so the cover is unlikely to be necessary.

- Since the photos I adjusted the dimensions so no additional gapping tape should be necessary around the sliding cover

- You will likely need bent nose pliers for holding the nuts while installing the bolts.

- Lower right nut installation is tricky, use double sided tape to hold onto it while installing the bolt.

- The design only has clearance for bolts with small heads (max 8-9mm diameter I think) so I recommend M4 X 30mm Allen Socket Bolts as pictured.

- Probably fits the X-Plus 3 as well, or anything that also uses a 80x80 fan but bed clearance is not guaranteed on other models.

- Later I've taped up the unused vent holes around the fan on the back plate, that design looks like an afterthought anyway - this way no unfiltered air can escape at the sides.

- It's mounted on the inside to accommodate those who don't have much space behind the printer (and a “pull” config works better anyway) but make sure there's enough clearance at the back to maintain good airflow & efficiency.

- After installation and taping up the vents around the fan it still maintains a 15.4 Km/h airflow which is probably at least on par with the original pellet bag. I never measued the original speed but without any filter it was 18.5 Km/h

 

Print instructions:

  • PLA is probably just fine, even if you plan to use it during high temperature prints.
  • It's a bit overengineered, more robust than absolutely necessary so I leave the wall count/infill settings to you (I used adaptive cubic)
  • What matters is to turn it sideways in the slicer so both of the steep sides are cooled equally by the auxiliary fan.
  • Add 1cm of brim to both sides and print it with the “fan side” at the bottom.

 

Tagi