1 / 11
Qidi X-Max 3 HEPA + carbon chamber filter (80x80 fan mount) — image 1
1 / 11

Qidi X-Max 3 HEPA + carbon chamber filter (80x80 fan mount)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Mainly for those who predominantly print PLA, where the HEPA is more important than the activated carbon.

Rating
0 / 5
Likes
21
Downloads
97
Makes
0
Views
1,006
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

HEPA (+ activated carbon) adapter for the Qidi X-Max 3, uses a Levoit LV-H128 replacement filter.

(Yes, the carbon is not pellet based, just an activated carbon impregnated sponge but I mainly print with PLA. And have a 550 CADR standalone purifier)

Disclaimer / tips:

- The additional sliding cover is just for OCD, to eliminate any unfiltered leakage around the filter, which has a foam padded edge. The ensclosure is tapered, the foam is compressed when insterted so the cover is unlikely to be necessary.

- Since the photos I adjusted the dimensions so no additional gapping tape should be necessary around the sliding cover

- You will likely need bent nose pliers for holding the nuts while installing the bolts.

- Lower right nut installation is tricky, use double sided tape to hold onto it while installing the bolt.

- The design only has clearance for bolts with small heads (max 8-9mm diameter I think) so I recommend M4 X 30mm Allen Socket Bolts as pictured.

- Probably fits the X-Plus 3 as well, or anything that also uses a 80x80 fan but bed clearance is not guaranteed on other models.

- Later I've taped up the unused vent holes around the fan on the back plate, that design looks like an afterthought anyway - this way no unfiltered air can escape at the sides.

- It's mounted on the inside to accommodate those who don't have much space behind the printer (and a “pull” config works better anyway) but make sure there's enough clearance at the back to maintain good airflow & efficiency.

- After installation and taping up the vents around the fan it still maintains a 15.4 Km/h airflow which is probably at least on par with the original pellet bag. I never measued the original speed but without any filter it was 18.5 Km/h

 

Print instructions:

  • PLA is probably just fine, even if you plan to use it during high temperature prints.
  • It's a bit overengineered, more robust than absolutely necessary so I leave the wall count/infill settings to you (I used adaptive cubic)
  • What matters is to turn it sideways in the slicer so both of the steep sides are cooled equally by the auxiliary fan.
  • Add 1cm of brim to both sides and print it with the “fan side” at the bottom.

 

Tags