1 / 2
Holder for the filament runout sensor on the Sovol SV07 — zdjęcie 1
1 / 2

Holder for the filament runout sensor on the Sovol SV07

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Holder for the filemant runout sensor which allows to keep the filament spool next to the printer, instead on top of it.

Ocena
0 / 5
Polubienia
10
Pobrania
71
Wydruki
0
Wyświetlenia
591
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

WARNING: I currently use this setup, but it can cause too much friction, if the spool is on the same height as the printer and the filament has to go up to the sensor an then back down to the print-head. 
Be sure you know what you do, if you use this setup.

 

The height of the Sovol SV07 with the filament spool on top is too high for where I want to put it.

In order to reduce the height, I am using the Spool holder for Prusa MINI Flexible. This got the spool out of the way.

This holder uses the existing filemant runout sensor to route the filemant to the print head from the spool, which sits next to my printer.

 

When printing, you need to insert a pause right a the layer that closes the opening for the M3 hexnut. When the print is paused, insert the hexnut (make sure it does not stick out) and then continue printing. 

Use the existing screw to connect the runout sensor to the holder, the holder just sits on top of the z-axes extrusion (can be mounted left or right).