1 / 3
Baratza Sette 270W Hook Cylinder
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement clamping ring for the Baratza Sette 270W
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 425
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Public Domain
After the original plastic part failed (see photo of the gray ring), I needed a replacement. This part isn't an exact match, but does the job.
Steps:
- Print part, using supports as required and 100% infill. I used PETG.
- Use soldering iron to remove screw insert from failed part. I used CNC Kitchen's TS100 insert adapter for this.
- Use soldering iron to place insert into replacement part.
- Disassemble grinder, per instructions
- Remove portafilter hook from broken cylinder
- Insert new cylinder into assembly, and place hook into new cylinder.**
- Tighten set screw on cylinder
- Re-assemble grinder, per instructions
** - This step was somewhat difficult, and I wasn't able to keep the spring that was supposed to go under this part. The spring isn't super necessary, however.
Replaces item #66, part #S549, “Hook Cylinder" from Baratza Sette 270W (and perhaps also Sette 270, Sette 270Wi, and Sette 30).