1 / 2
Blank Slate Case Switch
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A switch for phobus' blank slate case.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 27
- Wydruki
- 2
- Wyświetlenia
- 233
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Meant to fit into this blank slate case: https://www.printables.com/model/612623-blank-slate-high-profile-case
This switch makes it easy to turn you blank slate on and off with Phobus' case.
To install: print one switch and one case.
- Turn your Blank Slate PCB upside down and fit the switch onto the power switch in the off position.
- The two pins will go on either side of the switch and the overhand will hold onto the opposite side.
- Slot the PCB into the case at an angle so that the USB port goes in first, then slot the power switch through the hole.
- Firmly hold the PCB in place and add screens near to power switch first to ensure it doesn't slip out of place while adding screws.
- Turn it on and off a few times to ensure it's installed correctly.
This requires a decently tuned printer as it's a small part with an overhang. It should be printed without supports, as the overhand is small and a partner tuned enough to print this correctly should be able to handle the overhand.
Mine are printed with a 0.4mm nozzle and 0.2mm layer height.