Cascade Card Wallet Remix (Print-in-parts)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed so that parts can be printed flat on the print bed, and assembled without any fasteners.
- Ocena
- 5 / 5
- Polubienia
- 42
- Pobrania
- 212
- Wydruki
- 1
- Wyświetlenia
- 1943
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Important
• Model has zero tolerance, I wanted to avoid use of glue or screws so that it's very easy to put together (you might have to use pliers or something similar).
• Make sure to set up wall ordering outside to inside, so far I haven't had issues with parts not fitting.
• Sometimes cards are hard to pull out or fall out too easy, and it seems to be related to the front plate, but I haven't been able to figure out the exact issue, so if you do please let me know, thanks
Print the Strap Lock Top part as shown below, because that's the side that will be facing outwards
When printing the front plate rotate the part so that the bridging is done with the shortest route.
In my case I could only achieve the right rotation (z-90) by increasing Bottom Layers just enough to get to bridge layer, so keep that in mind.
Bad ❌ ↓

Good ✅ ↓

Assembly Steps:
Step 1:

Step 2:


Step 3:
If you are assembling the one with the elastic money strap, make sure to put the strap on the back plate first. (instructions after this step)

Elastic money strap instructions:
Pull the strap through on both sides

Put one side under the back plate to hold the tension, then pull the other one over the teeth on the Strap Lock Bottom part

Now pull the strap that was underneath over the other end and lock it in place with the Strap Lock Top part

Make sure its tight enough and you are done! Go back to step 3

From the original model ↓
Printing :
- I recommend printing in PETG (PLA tends to lose the tension with the cards over time)
- Nozzle : 0.4mm
- layer height : 0.2mm