CPAP Holder with strap holes and command hook plates
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
CPAP Tube and Mask holder with command strip plates, screw holes, and velcro strap holes.
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 85
- Wydruki
- 3
- Wyświetlenia
- 503
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted a combination of improvements for the CPAP holder by JayceFyrestorm over on Thingiverse, and so I basically combined the improvement ideas from servel333 and added plates for the hook to be mounted with command strips, as well as Debay777 and added holes to thread velcro to hold the hose in place. I also made sure that the screw holes were still able to be used just in case. Uses 2 medium size command strips if used.
Print Settings
Printer Brand:
Creality
Printer:
Ender-3 V3 KE
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.20
Infill:
50%
Filament: Sunlu PLA White, but literally doesn't matter
Notes:
Printed at 50% infill with Cubic. Wanted a little extra strength than the standard 20%, but honestly, 20% is probably fine. Also I printed with and without supports and they’re almost exactly the same, but YMMV. It uses the medium size command strips
Category: Organization