1 / 3
Powerbank housing for 8 x 18650 Lipos
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Slim replacement housing for a broken powerbank.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 52
- Wydruki
- 0
- Wyświetlenia
- 555
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
This slimline replacement for a broken powerbank case (8 x 18650 LiPos) is indeed a niche solution, but the connection section between the board and the batteries could be inspirational at best. All parts can be printed in place without supports.
Transparent filament was pushed through the holes to act as a light tunnel for the LEDs. 4x M3 12 mm countersunk head screws were used to close the housing.