1 / 3
Powerbank housing for 8 x 18650 Lipos
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Slim replacement housing for a broken powerbank.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 52
- Makes
- 0
- Views
- 555
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
This slimline replacement for a broken powerbank case (8 x 18650 LiPos) is indeed a niche solution, but the connection section between the board and the batteries could be inspirational at best. All parts can be printed in place without supports.
Transparent filament was pushed through the holes to act as a light tunnel for the LEDs. 4x M3 12 mm countersunk head screws were used to close the housing.