Voron 2.4 Z Chain Transpose
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Uses the X/Y cable chains (generic 3-hole or igus 2-hole mount) inplace of Z cable chain. Best with an umbilical mod.
- Ocena
- 5 / 5
- Polubienia
- 148
- Pobrania
- 1065
- Wydruki
- 11
- Wyświetlenia
- 6216
- Oceny
- 10
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Description:
My Voron 2.4 uses a Nighthawk SB toolhead board. Due to the cable thickness and exit direction from the board, the loop from the board to the lower strain relief mount either needs to be bent quite tightly or have extra room to comfortably move near the back of the gantry.
This Z-chain transpose mount moves the z chain below the gantry, keeping it out of range of the cable loop. This differs from other models by placing the chain in front of the gantry beam and adding zip-tie points. This allows a very clean cable path through to my Y endstop relocation and keeps the chain from running on the A/B motor wiring.
Parts:
If you're doing an endstop relocation and rebuilding the X and Y chains for this you should have all the parts already. Numbers are for generic cable chain (max)
- X/Y Voron cable chains (igus or generic)
- 6x M3x5x4 (Voron standard) heat set inserts
- 6x M3x6 flat head screws
- 2x M5x10 button head screws
- 2x M5 roll-in T nuts
- 2x zip ties
Print Settings:
0.4 mm nozzle, 0.2 mm layer lines, 40% infill
Updates:
2024-02-14 - fixed heat set insert hole diameter (4.5 → 4.7 mm)