on-target bullseye door
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
One time flip open or auto flip open and close target door.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 53
- Wydruki
- 0
- Wyświetlenia
- 327
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial
on-target bullseye door. This can be a one shot latched door when mounted hinge to the bottom or it can be an open swing entry and re-close door when the hinge is mounted upward.
This on-target fixture was designed for the 6-Shot Disc Shooter by uhltimate but can be used with other things.
There are pre-rendered supports in the clips. Cut them out. No beauty needed in the finish.
The latch for the door is simply a pressure hole into the frame.
Printing
- These are thin wall fixtures.
- Good layer adhesion required
- designed for .4mm at 2mm layer.
- Frames print face down
- Remove the support material from the springs
- Doors print face up so you can customize them
CUTTING the box
Cutting holes could be dangerous. Use caution to avoid personal injury. Certain power tools may be facilitate cutting.
- For this one you will need the template. You should be able to cut on the lines.
- Any pressure on the frame from a deformed hole could prevent the latch from engaging.
The box:
- 3-7mm thick is good.
- Less than 3mm you may need to place the templates in the back to make the space behind the clips closer.
Assembly
- The reset lever slides through the front, put the door on and slip the pin through.
- Place the door
- Insert the pin
Other models:
on-target spinner target
on-target disc shooter hoop track
Don't Forget Night Mode
Put a flashlight in the box and enjoy illuminated targets.