on-target bullseye door
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
One time flip open or auto flip open and close target door.
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 53
- Makes
- 0
- Views
- 327
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial
on-target bullseye door. This can be a one shot latched door when mounted hinge to the bottom or it can be an open swing entry and re-close door when the hinge is mounted upward.
This on-target fixture was designed for the 6-Shot Disc Shooter by uhltimate but can be used with other things.
There are pre-rendered supports in the clips. Cut them out. No beauty needed in the finish.
The latch for the door is simply a pressure hole into the frame.
Printing
- These are thin wall fixtures.
- Good layer adhesion required
- designed for .4mm at 2mm layer.
- Frames print face down
- Remove the support material from the springs
- Doors print face up so you can customize them
CUTTING the box
Cutting holes could be dangerous. Use caution to avoid personal injury. Certain power tools may be facilitate cutting.
- For this one you will need the template. You should be able to cut on the lines.
- Any pressure on the frame from a deformed hole could prevent the latch from engaging.
The box:
- 3-7mm thick is good.
- Less than 3mm you may need to place the templates in the back to make the space behind the clips closer.
Assembly
- The reset lever slides through the front, put the door on and slip the pin through.
- Place the door
- Insert the pin
Other models:
on-target spinner target
on-target disc shooter hoop track
Don't Forget Night Mode
Put a flashlight in the box and enjoy illuminated targets.