Stackable Sieve
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Stackable Sieve Sieve frame with insert to take a wire mesh approximately 150mm (6 inches) square. The outside is…
- Ocena
- 0 / 5
- Polubienia
- 61
- Pobrania
- 241
- Wydruki
- 2
- Wyświetlenia
- 2077
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
Stackable Sieve
Sieve frame with insert to take a wire mesh approximately 150mm (6 inches) square.
The outside is 155mm square which is the largest that will fit on my print bed. The sieve has a coarse mesh to support your wire mesh or with no support if you are not giving it hard use.
I provide a pot to catch your powder.
There is a lid which can be useful when shaking the sieve.
Print the box, cut your sieve mesh to fit using the insert as a size guide then glue all in place with an impact adhesive.
This should be printed in a plastic with good layer adhesion. Use PLA or PETG as ABS will warp.
Print Settings
Printer:
Any
Rafts:
No
No
Resolution:
0.20 or 0.25 layer height
25%
Filament: . PLA or PETG .
Category: DIY