Stackable Sieve
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Stackable Sieve Sieve frame with insert to take a wire mesh approximately 150mm (6 inches) square. The outside is…
- Rating
- 0 / 5
- Likes
- 61
- Downloads
- 241
- Makes
- 2
- Views
- 2,077
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution
Stackable Sieve
Sieve frame with insert to take a wire mesh approximately 150mm (6 inches) square.
The outside is 155mm square which is the largest that will fit on my print bed. The sieve has a coarse mesh to support your wire mesh or with no support if you are not giving it hard use.
I provide a pot to catch your powder.
There is a lid which can be useful when shaking the sieve.
Print the box, cut your sieve mesh to fit using the insert as a size guide then glue all in place with an impact adhesive.
This should be printed in a plastic with good layer adhesion. Use PLA or PETG as ABS will warp.
Print Settings
Printer:
Any
Rafts:
No
No
Resolution:
0.20 or 0.25 layer height
25%
Filament: . PLA or PETG .
Category: DIY