Moza R5 Base Mount

Better bracket to mount your Moza R5 base. Original bracket is too big, made for fitting oversized tables 50mm thick, and also the base comes too close I think.

This one makes it as low as possible while still maintaining the original tilt angle. And you can choose yourself how close it should be. Clamp it with your preferred clamps and you will lift your desk sim experience a notch.

Print mount with “up side” up, support on build plate only. Print two supports.

/Edit, 24 March 2024. I moved/added holes in bracket "Y-axis" to make it fit various sized wood better.

Extra material needed:

1. 4x M6x12 flat head screws (original screws don't work well)
2. 9x 4.5x20 mm wood screw (or slightly smaller)
3. Piece of wood 20mm thick. I have one 600x115 mm.
4. 2x clamps (if you don't cut a slot in your table :) ...)

Cut a slot in your wood and assemble the pieces like this:

Then just clamp it to your desk and go burn some digital rubber!

Note (the other model)

If you would prefer to go all-in with a version that sits in a slot in your desk. I have a “full” version here:

https://www.printables.com/model/948265

Other MOZA prints?

Check out my full collection of other printables for MOZA eco system. There is a bunch of various other things of all kinds:

https://www.printables.com/@BentDerailleur/collections/1579905

Happy driving!