HMG7 Alternative Hotend Groove Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Inspired by The 100 toolhead. Designed because getting the hotend out of the original was too difficult.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 358
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Due to my bad habit of damaging my nozzle and hotend, I often had to dissassemble the HMG7 toolhead and getting the original groove mount out of the heatsink proved nearly impossible without causing damage to something. So I designed this. If this style of mount is good enough for The 100, I'm sure it will be fine for most printers.
Additional Hardware:
2x M3 12mm screws
2x heat inserts (the kind that goes on the The 100 because I just forgot they were a different size from the HGM7 heat inserts)