1 / 2
HMG7 Alternative Hotend Groove Mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Inspired by The 100 toolhead. Designed because getting the hotend out of the original was too difficult.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 27
- Makes
- 0
- Views
- 359
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Due to my bad habit of damaging my nozzle and hotend, I often had to dissassemble the HMG7 toolhead and getting the original groove mount out of the heatsink proved nearly impossible without causing damage to something. So I designed this. If this style of mount is good enough for The 100, I'm sure it will be fine for most printers.
Additional Hardware:
2x M3 12mm screws
2x heat inserts (the kind that goes on the The 100 because I just forgot they were a different size from the HGM7 heat inserts)