DE Razor Blade Pack Dispenser Tower
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Dispenser tower for packs of double-edge safety razor blades
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 73
- Wydruki
- 1
- Wyświetlenia
- 1080
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Update 2025.04.23 - Since I have a larger printer now, I made a taller 22cm version that easily accommodates a 100-pack in 5-blade packs.
This dispenser tower for packs of double-edge safety razor blades was built from scratch, but was inspired by the one created by Rolts. I wanted them to dispense from the narrow side, I wanted an open slot so it's easy to reach in and move the packs, and I wanted to make it as tall as my Prusa Mini could print, which is 18cm tall.
I use a red extra fine tip Sharpie marker to write the date used on each razor pack, so I added a marker holder with an 11mm diameter hole on the front. I also uploaded a version without the marker holder.
A hard plastic 5-pack of Derby blades is about 53mm x 30mm x 11mm, and this tower can hold 17 of those. If you're using cardboard packs that are less tall, this could fit a couple more.
Print Settings
Rafts: No
Supports: Yes
Resolution: 200
Infill: 15
Filament: PLA
Notes:
Paint on supports for the bottom opening.
Neither the Sharpie holder now the arches at the top of the finger slots require supports.