Voron 0.2 Mid_plate_Hex split for 220mm plate
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of Bestagon midplate v0.2 to fit on my Aquila Added Voron Logo medallion as a connector
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 273
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Wanted to print the Bestagon midpanel but it wouldn't fit on my aquila with room for a brim.
Split in half and added the Logo for asthetic reasons. Made it a bolt on connector using M3 screws.
Designed in Tinkercad so my measurements were off when adding the holes. The Logo only sits in the inset and screws in from one orientation.
If the holes do not line up and your calibrations are good, rotate the logo 180deg.
If you use a 4mm screw, it will sit flush to the panel.
Printed using Voron standard settings in black ASA with a brim on each part.
Demo photo shows mid processing. Welded seam with acetone and sanded down high points on print.
If I remember to, I'll add a final product pic. :)