1 / 2
Bottle rack
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A modular water bottle rack that can print stacked.
- Ocena
- 5 / 5
- Polubienia
- 740
- Pobrania
- 2258
- Wydruki
- 28
- Wyświetlenia
- 10 317
- Oceny
- 25
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 28) (Komentarze: 49)Remiksy (6)Kolekcje (1156)Powiązane
I wanted to challenge myself to design a water bottle rack that could hold 12 water bottles and also be printed/assembled in less than 1 day.
Note: pictured 32oz Nalgene only fits on top row
Non-Printed Parts
- for each bottle x2 - 5/16" (8mm) wood dowels cut to 7.5" (190mm)
* UPDATE: there are now remixes for printed dowels if thats your jam.
Print Settings
I suggest printing a couple of the smaller top models to test tolerances/fit before full send. The parts off my printer fit fairly tight and took some force to assemble.
*Stacked print settings*
- Layer Height: 0.2mm (required for stacked model stls)
- Perimeters: 2 is sufficient for structure
- Infill: 10-15%
- Bottom shell layers: 4
- Ironing: (Optional) All top surfaces
Example of sliced plate printing in 10hrs for 12 bottles (no ironing)
Assembly
- Assemble both printed part sides
- Attach cut dowels to one side
- Set the dowel side on a flat surface with dowels facing up
- Install the other side - place second assembled side on top aligning the dowels and getting them started into the holes. Start from one side pressing the dowels until they are fully seated.