Invisible MagSafe Charger - Routing Template
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Routing templates for MagSafe chargers and a holder clamp.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 534
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
These routing templates and clamp allow you to hide a MagSafe charger in a tabletop. Just use the templates to router the deep pocket for the charger and shallower areas for the clamp which is screwed in place.
There are default templates for an 8 mm router bit, a template guide with a diameter of 16.8 mm and a ESR MagSafe charger from Amazon. The Fusion file is also attached so you change the parameters.
Instructions: Before using the router, drill two holes for alignment. Align the round router template with its pins into the holes and use double sided tape to lock it into place. Route deeper and deeper. Put the charger into the holes for testing. When deep enough, remove the round template and align the template with the pockets using the two drill holes. Use double sided tape again for locking it into place. Then route the pockets for the crossbar that later fixes the MagSafe charger into its place. Note: these pockets need to be less deep so the four screws of the crossbar have something to hold on to.
You need to adjust the router depth yourself.