Mono M5(s) Build Plate Drip Hanger
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Leave in place build plate drip hanger. Requires two M3*20 screws and two M3 nuts
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 180
- Wydruki
- 0
- Wyświetlenia
- 868
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This bracket attaches to the ‘head’ of the build plate and allows you to quickly remove the build plate after printing, rotate it 45 degrees and slide it back on and allow the excess resin to drip.
- Leave in place solution
- Does not interfere with printer operations
- Does not dip below the top of the resin vat
- Can be printed in resin or on an FDM
Requires two M3x20 screws and two M3 nuts
When assembling note the orientation of the spacers and the caps, the screw holes are off center. The spacers will have the the open side facing out, with the narrow side facing the front of the build plate. The caps will have the rounded side facing out with the narrow side facing the build plate
Only hand tighten the screws.
For FDM printing I used PETG with a .2mm layer height, 15% infill on a .4 nozzle