1 / 5
Fire extinguisher holder for the trunk of a car
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fire extinguisher holder for quick access in the trunk.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 671
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (25)Powiązane
The holder is at a 20-degree angle, and for attachment in the trunk, adhesive hook and loop fasteners are required. Part of the fasteners will adhere to the bottom of the holder, and part to the side, where a flat surface is prepared for them. No supports are needed. Due to the temperatures that can occur in the car during summer, I would recommend TPU. However, since I didn't have it, I used PLA. If there is an issue, I will reprint the holder.
The inner diameter is 83.5mm and the height of the tube is 140mm.