1 / 3
Motorola Talkabout T460 Holder
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wall mount holder for Motorola Talkabout model T460
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 64
- Wydruki
- 0
- Wyświetlenia
- 422
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Public Domain
Wall mount holder remixed for Motorola Talkabout T460 frs radios
adjustments from original model:
- flipped side for charge port access
- scaled up
- adjusted cutouts
- useless height removed
- mounting holes added
Two versions available in .stl for either screw mount (4.2mm holes) or pin nail mount (1.3mm holes). Adjust parameter “D_ScrewHole” in the fusion file if neither of these work for the screws you want to use.
Notes:
- Tolerances are loose, which is fine for upright design in a static environment. If adapting for in-vehicle or van mount you'll probably want to test and scale down accordingly.
Print settings:
- layer height: 0.22mm
- nozzle: 0.4mm
- Material: PETG (any non-flexible material is probably fine - its only 15g of filament so start with whatever you have loaded as waste is of little concern)
- Depending on bridging capabilities, may need support for front cutout. Higher fan speed mostly did the trick for me (set to higher fan speed at height before bridge)