VRM fan mount x99 P4
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
VRM dual fan mount for x99 AliExpress boards (P4 / ED4) to avoid burning out the VRMs.
- Ocena
- 0 / 5
- Polubienia
- 23
- Pobrania
- 212
- Wydruki
- 0
- Wyświetlenia
- 2337
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
VRM fan mount for AliExpress x99 board.
Created for MUCAI P4
Boards with similar design
ZSUS P4
MOUGUL P4
QIYIDA ED4 (different color)
If your VRM cooling looks like this it will fit.
It might work on other similar boards but I can't test that.
Made for use with two 40x40 fans, print in ABS preferably but PETG should work depending on how hot your VRMs get. Mine is printed in black ABS and keeps my VRMs at about 50-60C at full load using a 2680v3 with all core turbo unlocked and pegged at 3.3Ghz (a 120TDP CPU).
The print is fairly easy and needs minimal support if any, the holes are 3mm. It clamps on well and sits firm without crushing the heat sink, it's supported against the motherboard on the CPU side, it clears caps and chokes, doesn't interfere with CPU fan connector or RAM and should work with most CPU coolers. Screw it on from the “lock” part side (from above on the motherboard).
Most airflow is directed in to the heat sink but there is also some that go to the chokes and caps.