1 / 6
TPU gasket for X1C/P1S/P1P top plate REMIX
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I remixed the model by @SrenHejnfelt_1203880 for use on the top of the printer rather than on a riser.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 54
- Wydruki
- 0
- Wyświetlenia
- 511
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (12)Powiązane
- I printed this in 95a TPU with a 15% concentric infill.
- I used a .4mm nozzle with a .16 layer height using the “Generic TPU” preset in Bambu Slicer. I'm sure a .2mm nozzle with even a finer layer height would look a lot better as well.
- I used standard supports everywhere.
- I also printed this on the Bambu Lab High-Temperature plate. (not recommended without applying glue or some kind of separator before)
- I was testing out the fitment and have not glued it down to the printer yet. I'm deciding to print this in a black 95a TPU then deciding to glue down.
- *From the prints that I've ran after including the gasket under the lid* The vibration of the lid was way quieter especially when the printer was performing the input shaping calibration.
