Two Trees Bluer Plus X limit switch offset
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Center the X-axis to utilize 300x300 print space on the 310x310 bed.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 238
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Easy fix to an annoying problem. Somehow the printer has a 310x310 bed and the X and Y limit switches line up to the edges of the bed.
We cannot utilize the full 300x300 bed size if 0,0 is at the edge of the bed. This is a failure of the written firmware to effectively utilize the 5mm border meant to provision bed alignment variance. I am trying to avoid going down the firmware rabbit hole for now.
This design solves the X-axis by adding a boot to extend the trigger by 5mm.
Y-axis trigger is a screw, and while easy to get a working solution, I am thinking about how to implement a fix without disassembling a lot of parts.
Customisation hacks
- If you like shorter than 5mm, move the part down to your desired height on the slicer bed. It should only slice the 3D model that is above the bed.
- If the part is too tight or loose, play with the scaling by 1% to 2% increment till you get a good fit.
As always, everyone's 3D print will be slightly different. Play around with the slicer to resize the part to fit.
*****
Want to buy me a coffee?
https://www.buymeacoffee.com/zer0s
Clicking on my affiliate links below will give me a small kickback if you purchase something. (at no extra cost to you)
AliExpress affiliate link:
https://s.click.aliexpress.com/e/_DmpFxU1
*****
Consolidated affiliate links of other 3D printing-related items:
https://wp.me/peMLu6-j
For Amazon affiliate links
https://wp.me/peMLu6-2C