1 / 1
Neutrik NA enclosure mount for K&M Microphone Stand Boom Arm — zdjęcie 1

Neutrik NA enclosure mount for K&M Microphone Stand Boom Arm

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a mount which magnetically attaches a Neutrik NA multipurpouse enclosure to the joint of a K&M microphone stand.

Ocena
0 / 5
Polubienia
7
Pobrania
16
Wydruki
0
Wyświetlenia
415
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Audio
Licencja
Creative Commons — Attribution — Noncommercial

I needed a microphone stand mounted inline switch for a microphone.  I built it into a Neutrik NA extruded aluminum enclosure (it's also available printable).   This print surrounds the outside of the aluminum housing.   The lower half takes a bit of effort to snap in.  4x 4-40 screws go through the Neutrik D-Series connectors, through the print, into the extruded aluminum.   I included 8 holes in the print, but only two per side are required.    
 
There are spots for up to 10x 10mm x 1.75mm magnets if you want it extra secure.  You could also just wrap some gaff tape around it.  :)

 

Tagi