1 / 6
ender 5 /Mercury One.1 | voron legacy dual Z mod — zdjęcie 1
1 / 6

ender 5 /Mercury One.1 | voron legacy dual Z mod

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

this convert the stock ender 5 Z motion system to a very stable dual Z motion system with z tilt

Ocena
5 / 5
Polubienia
67
Pobrania
261
Wydruki
1
Wyświetlenia
3054
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v3.0

So i made a remix of the Voron legacy Z motion system to be used on a Mercury One.1 .it introduced a way more stable bed with Z_tilt capabilities for a very little price.

YOU NEED TO  cut the stock Z motion system 2020 extrusion down to 130mm each

if you have question about firmware config you can message me on discord but im not the best … “polo_61” on discord

the bed is not centered on purpose to get maximum build volume.

so you need :

-x1 370mm lead screw with nut (same lenght as the original one) 

-x1 motor for second Z

-bigger motherboard with at least 5 drivers

-x4 380mm long 8mm rods

-M5x16 BHCS srews x16 i think

-m5x10 BHCS x8 not shure too 

-m3x8 x8

-x4 lm8luu linear bearing

i reused the stock Z motion system 2020 extrusion and cut them down to 130mm each

the “Legacy_Ender3_bed_mount_x2” file was remixed from the original legacy files by steve buils (steve.21 on discord) credit to him .
 

note that BOM might not be exact but if i forgot something ping me on discord “polo_61”

Tagi