ender 5 /Mercury One.1 | voron legacy dual Z mod
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
this convert the stock ender 5 Z motion system to a very stable dual Z motion system with z tilt
- Rating
- 5 / 5
- Likes
- 67
- Downloads
- 261
- Makes
- 1
- Views
- 3,054
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- GNU General Public License v3.0
So i made a remix of the Voron legacy Z motion system to be used on a Mercury One.1 .it introduced a way more stable bed with Z_tilt capabilities for a very little price.
YOU NEED TO cut the stock Z motion system 2020 extrusion down to 130mm each
if you have question about firmware config you can message me on discord but im not the best … “polo_61” on discord
the bed is not centered on purpose to get maximum build volume.
so you need :
-x1 370mm lead screw with nut (same lenght as the original one)
-x1 motor for second Z
-bigger motherboard with at least 5 drivers
-x4 380mm long 8mm rods
-M5x16 BHCS srews x16 i think
-m5x10 BHCS x8 not shure too
-m3x8 x8
-x4 lm8luu linear bearing
i reused the stock Z motion system 2020 extrusion and cut them down to 130mm each
the “Legacy_Ender3_bed_mount_x2” file was remixed from the original legacy files by steve buils (steve.21 on discord) credit to him .
note that BOM might not be exact but if i forgot something ping me on discord “polo_61”