LED Strip Light Reflectors for IKEA Lack Enclosure (or other)

Edit - mine has been replaced with a new design to use current COB LED strips with a PWM dimmer: https://www.printables.com/model/870280-cob-led-strip-housing-use-for-lack-or-other-enclos

Post a make if you make a set! :)

I needed to mount these LEDs in my Lack case but wanted to angle them at the printer and not so much outside my enclosure.

(3) 45º reflectors
(1) rear reflector (no angle)

NOTE: The cable bundle runs down my front left pillar when this cover is installed - they are not mounted to the top in the image like it may appear. :)

Ordered the 48 LED USB port lights here (~$15):
https://www.amazon.com/gp/product/B076LNTN79/
These have very good gummy adhesive. Just use a USB power adapter to power.

Mounted with (12) #8 1/2" wood screws.

If desired to print black / white for the side and top front reflectors, rotate the object in your slicer program so the screw hole surface is perpendicular to the print surface so you print the outer layer first for 3 layers of black then switch to white. Prompted color change by uploading your gcode here and specifying .8 on the slider. Wanted the white to reflect any light that hits it back into the enclosure while somewhat making the reflector less noticeable by having the outer face black to blend in.
https://blog.prusaprinters.org/color-print/

Passed the cables through my table to power below from a power strip via this: https://www.thingiverse.com/thing:2573459

Print Settings

Supports:

Yes

Resolution: 

.2 layer

Infill:

10%

Filament: n/a PLA is fine. Black (w/ optional white) 
 

Notes: 

Supports are good if printing with the screwholes perpendicular to the print surface.

Category: 3D Printer Accessories