1 / 2
AWCY 3D TACTICAL 2A PRO AR JIG - READYMILL 15MM TO 1/4" OR 5/16" ADAPTER BUSHING AND SPACERS — zdjęcie 1
1 / 2

AWCY 3D TACTICAL 2A PRO AR JIG - READYMILL 15MM TO 1/4" OR 5/16" ADAPTER BUSHING AND SPACERS

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

If you can't find the 5D Tactical READYMILL 5/16 endmill, use 1/4". Aluminum bushings need to be changed out for .25 OD

Ocena
0 / 5
Polubienia
6
Pobrania
91
Wydruki
0
Wyświetlenia
878
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Public Domain

AWCY 3D TACTICAL 2A PRO AR JIG READYMILL 5/16" TO REGULAR ¼" BIT ADAPTER KIT

If you have printed the jig you may not be able to readily find the READYMILL adapter and 5/16 endmill tools that are designed to fit it…  You may have noticed a lot of "OUT OF STOCK" notices.

This is my attempt to adapt a 1/4" endmill/router/some other bit for use in the jig.

If you have the 6002-Z bearing in your router plate - the bushing steps down from the 15mm ID of the 6002-Z to 1/4".

This version is slightly tighter and longer - 15mm-to-quarter-in-bushing-only_0.4n_0.2mm_PLA_MK4_20m

Also added 5/16" bushing

Also provided the 3 sizes of printable bushings, because those will need to change to 1/4" OD.
The originals specified are 8mm, which is ~5/16 - your milled out lower interior will end up 
about 1/16" too narrow if you use the 8mm spacers and a 1/4" bit.

( I do not have much faith in printing these small/narrow bushings… The vertical ones printed fine on my printer and tracked in the guide just fine. YMMV. Maybe the hardware store has nylon ¼ OD x .166 ID bushings that can be filed and fit.  Also, the 8-32 inserts may cause an alignment problem if their holes are bigger than .25 - may fall into or askew in the hole)


These are the aluminum 1/4" spacers that you can purchase from McMaster.

ALL 1/4" OD x .166 ID:
Bushing Step 1 - 5/32" - PN: 92510A032 
Bushing Step 2 - 5/16" - PN: 92510A463
Bushing Step 3 - 1/2" - PN: 92510A465

ALSO NOTE: The screw head diameter of the 2 screws specified in the AWCY Jig instructions to hold the 8mm aluminum step bushings are .27in.  These 2 screws head diameter needs to be ground down to less than  (or equal…) to .25in .  The .02 may not make a difference, 
Chuck the screws in a drill and run them against a file or bench grinder, etc.

Original screws - PN: 90665A114
Alloy Steel Low-Profile Socket Head Screws, Hex Drive, Zinc Plated, 8-32 Thread Size, ¾" Long

Tagi