1 / 3
Cirqus Voltaire Bumper Bracket — zdjęcie 1
1 / 3

Cirqus Voltaire Bumper Bracket

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Printable replacement part for NLA rubber bumper bracket (04-10253) used on Bally Cirqus Voltaire pinball machines.

Ocena
0 / 5
Polubienia
1
Pobrania
19
Wydruki
0
Wyświetlenia
158
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

I printed it with full infill and it has been holding up fine for a few months.  You will need an M3 tap to create the threads but the pilot hole is sized properly so you can just run a tap through it. You'll also need a 10mm long M3 screw.  The boss that pokes down inside the rubber bumper makes for a pretty long thread section so the screw engagement is quite strong. The thicker shape does not interfere with the ball passing behind/near the bracket.

Also, for completeness I used P/N 23-6766 from Marco Pinball for the blue bumper itself.