1 / 2
MeanWell LRS-350 Power Supply Cover
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modify your MeanWell LRS-350 to support a 120mm fan!
- Ocena
- 5 / 5
- Polubienia
- 19
- Pobrania
- 128
- Wydruki
- 1
- Wyświetlenia
- 1664
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 1) (Komentarze: 5)Remiksy (0)Kolekcje (55)Powiązane
This alternate case cover allows you to use a 120MM fan with your Meanwell LRS-350 case. It includes inset text for easy identification of terminals. Requires M3 hex nuts and M3x10mm screws close up, and a 120MM fan.
- I used a Noctua NF-F12 iPPC 3000 fan but it was pretty loud in its stock configuration.
- I then added Noctua NA-SRC7 Low Noise Adapters to reduce the noise
- You will likely need to convert your fan from 3/4 pin to 2 pin. This is a simple game of “match the colors”, twist wires together (or wirenut, WAGO, solder, etc) , and isolate with either heat shrink or electrical tape.
By upgrading to a 120mm fan, the noise level of the LRS-350 will go from very, very loud to barely audible, just like your silent MK3S deserves!