1 / 2
MeanWell LRS-350 Power Supply Cover
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Modify your MeanWell LRS-350 to support a 120mm fan!
- Rating
- 5 / 5
- Likes
- 19
- Downloads
- 128
- Makes
- 1
- Views
- 1,664
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
This alternate case cover allows you to use a 120MM fan with your Meanwell LRS-350 case. It includes inset text for easy identification of terminals. Requires M3 hex nuts and M3x10mm screws close up, and a 120MM fan.
- I used a Noctua NF-F12 iPPC 3000 fan but it was pretty loud in its stock configuration.
- I then added Noctua NA-SRC7 Low Noise Adapters to reduce the noise
- You will likely need to convert your fan from 3/4 pin to 2 pin. This is a simple game of “match the colors”, twist wires together (or wirenut, WAGO, solder, etc) , and isolate with either heat shrink or electrical tape.
By upgrading to a 120mm fan, the noise level of the LRS-350 will go from very, very loud to barely audible, just like your silent MK3S deserves!