1 / 3
VL53L0X Magnetic Enclosure for Gaggia Classic / Gaggiuino
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Enclosure for VL53L0X breakout board to mount on your Gaggiuino.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 68
- Wydruki
- 0
- Wyświetlenia
- 775
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (13)Powiązane
If you want to use the cheap VL53L0X breakout board with your Gaggiuino as a water level sensor, here is an enclosure for it.
Parts needed
- 2 disc magnets, 5 mm dia. x 2 mm ht. (same as for Scales Mod)
- VL53L0X breakout (I have the purple one, black should work, too)
Instructions
- Print the parts
- Put the ToF breakout board into the bottom part, connect the wires (make sure they are thin, as the other end needs to fit into a JST SH connector).
- Place the magnets in the top part of the enclosure. Place a strip of insulation tape over them to hold them in place and ensure they do not short any connections on your breakout board.
- Put the two halves together, and connect them with a piece of filament, ziptie, or fuse it with a lighter.
- Install the sensor over your water tank.
As with my other models, you find the source files attached, in case you want to tinker with it yourself.
