1 / 3
VL53L0X Magnetic Enclosure for Gaggia Classic / Gaggiuino — image 1
1 / 3

VL53L0X Magnetic Enclosure for Gaggia Classic / Gaggiuino

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Enclosure for VL53L0X breakout board to mount on your Gaggiuino.

Rating
0 / 5
Likes
13
Downloads
66
Makes
0
Views
769
Reviews
0

Updated at source:

Model information

Category
Kitchen
License
Creative Commons — Attribution — Noncommercial — Share Alike

If you want to use the cheap VL53L0X breakout board with your Gaggiuino as a water level sensor, here is an enclosure for it.

Parts needed

Instructions

  • Print the parts
  • Put the ToF breakout board into the bottom part, connect the wires (make sure they are thin, as the other end needs to fit into a JST SH connector).
  • Place the magnets in the top part of the enclosure. Place a strip of insulation tape over them to hold them in place and ensure they do not short any connections on your breakout board.
  • Put the two halves together, and connect them with a piece of filament, ziptie, or fuse it with a lighter.
  • Install the sensor over your water tank.

As with my other models, you find the source files attached, in case you want to tinker with it yourself.